GE NX-148E

How to To Add or Change User Codes

1. Ensure your system is disarmed

2. Press [*] [5].

3. Enter a Master Arm/Disarm code.

4. The ready light will flash.

5. Enter the 2-digit user number (always enter 2 digit such as [0] - [3] for user 3, or [1] - [2] for user 12).

6. Enter the new 4 or 6 digit user code.

7. The ready light will flash indicating you are back at step 4. If the code is rejected, the sounder will beep 3 times.

8. If another user code needs to be programmed, return to step 5.

9. Press the [#] key while the ready light is flashing to exit the User Code Programming Mode.

How to Delete User Codes

1. Ensure your system is disarmed

2. Press [*] [5].

3. Enter a Master Arm/Disarm code.

4. The ready light will flash.

5. Enter the 2-digit user number (always enter 2 digit such as [0] - [3] for user 3, or [1] - [2] for user 12).

6. Enter [*][*] [*] [*] for a 4-digit code or [*] [*] [*] [*] [*] [*] for a 6-digit code.

7. The ready light will flash indicating you are back at step 4. If the code is rejected, the sounder will beep 3 times.

8. If another user code needs to be programmed, return to step 5.

9. Press the [#] key while the ready light is flashing to exit the User Code Programming Mode.

How to Access Bypass Zone

1. Press the [BYPASS] key.

2. Enter user code, if required (optional). The bypass light flashes.

3. Enter the 1-digit number for the zone you wish to bypass. (Example: Press the [1] key for zone 1, press [4] for zone 4.)

4. Press the [BYPASS] key again.

5. The corresponding zone light will illuminate indicating the zone has been bypassed. Repeat steps 3 and 4 for any other zone(s) that need to be bypassed.

6. Press the [BYPASS] key again -or- press the [#] key to exit the Bypass Mode. The bypass light will stop flashing upon exiting the Bypass Mode

How to Turn On/Off Chime Mode

To turn Chime Mode on, press the Chime Button.  The keypad chime LED will light and the keypad will chime indicating that the chime is enabled.

 

To turn Chime Mode off, press the Chime Button.  The keypad chime LED will extinguish and the keypad will chime indicating that the chime is disabled.

How to Reset Smoke

1. Disarm the system if not disarmed.

2. Press [*]-[7].

3. If the keypad begins beeping, the reset did not execute properly. Enter your code to silence the keypad. Wait a few minutes and repeat step 2 to attempt another reset. If the keypad still beeps after repeated attempts, please contact Quantum Security and Innovations.

How to Access Service Menu

The service light will be “on” if the security system requires service. If the service light is “on”, press the [*] key followed by the [2] key to determine the service condition. One or more zone lights will illuminate indicating what service(s) is required. Call your service provider immediately for these problems. 

Press the [#] key to return to the 1 of 8 service lights.